AUTO COUPLING AND BASE STAND

Our submersible pump is easy to detach and attach with using the Auto coupling and base stand when the pump is needed to repair or replace due to failure and its life cycle.

Installation

1. Do not use pump cables to lift the pump or pullit cable during transportation, installation.

2. The pump should not be laid down on its side or hang it from the air. Please stand it on the floor.

3. If the liquids in absorption tank makes wave, Please fix the pipe properly.

4. Make sure that if the air is not staying in piping.

5. If the end of discharge pipe is immersed in water, the water will flow back when the pump is stopped. Do not immerse the end of discharge pipe in water.

6. When install a level switch (FLOAT switch, etc.), make sure that it dose not contact with the wall if the tank and pipe.

7. When install the auto coupling and base stand, the size of the foundation bolt, installation area, installation site, installation method and etc. Should be considered.

8. To lift pump, attach the ring to the proper location so that the wire rope connected to the pump does not fall into the water, and tie the wire rope to the ring.

ACCESSORIES

. Our submersible pump is equipped with the pump fault prediction, accordingly it is possible to do monitoring for the motor temperature and leakage

· Through the wireless network system, the status of pump can be checked by computer and mobile phone which is within a range of 2Km. The work efficiency can be improved as well.