Auto drain trap manufacturer, Power drain trap, Strainer attached valve and more
Advantages
- Exclusive reciprocating compressor
- The installable small size in the bottom of R-tank.
- Working by compressor loading and unloading
- Free installation regardless of direction.
- Manual drain discharge is available
- The optional valve sticked strainer
Specifications
|
SPECIFICATION |
|||||
|
MODEL |
In/Out port |
OPTION |
Using Pressure |
Using Temp. |
Compressor |
|
WRCT-08 |
1/4" |
- |
0 ~ 9.9 kgf/㎠ |
2 ~ 75 ℃ |
3 ~ 20HP |
|
WRCT-08-I |
1/4", 1/2" |
I-STRAINER |
|||
|
WRCT-08-Y |
1/2" |
Y-STRAINER |
|||
Auto Drain Working Status
|
The 1st press.(R/Tank) |
The 2nd press.(Head) |
Compressor Working Status |
Drain Status |
|
0.2~2.0 kgf/㎠ |
0.2~2.0 kgf/㎠ |
Same pressure (In the case of compressor working) |
OPEN |
|
Over 2.0 kgf/㎠ |
Over 2.0 kgf/㎠ |
Same pressure (After pressure rising) |
CLOSE |
|
Over 5.0 kgf/㎠ |
2.0~4.0 kgf/㎠ |
In the case of Compressor running- Loading/Unloading |
OPEN |
* The 1st press. : Inside pressure of air receiver tank (Inlet pressure of trap)
* The 2nd press. : Pressure between compressor head & check valve (Balance line pressure of trap)
Dimension
Installation
1. Stop air compressor and install.
2. The 1st piping of trap: Connect to the drain of receiver tank
3. The 2nd piping of trap: Connect to the using air vent line (Solenoid valve or pressure switch)
4. Check how it works after installation (Refer to the previous page Auto drain Working Status )
