Dust collector manufacturer, Air bank, Pulse valve, Gauge, Timer and more
1.Aluminum Die-Casted Box
As the PCB of TNX timer is located in the aluminum dis-casted box, it facilitates the water-proofing and
dust-proofing.
2.All function in Digtal
Using the highly quantitative micro-computer circuit, when the noise inflow from the outside, the program
in the EP-ROM pack senses the noise, and performs the function of auto-compensation.
3.Pre-Wired with Solenoid
TNX timer includes the built-in solenoid coils(PM-63) and all necessary wiring. There should be no
need to wire between timer card and solenoid coil to prevent humidity/dust from corrosion of coil.
4.Exterior design for all controls
It has exterior displays like main power switch, time setting keys. These exterior displays allow the
monitoring, time setting and damage checking of the timer without opening the timer case.
5.Free Voltage Function
This timer board has a free voltage function (AC85 ~ 240V/50 ~ 60Hz)
6.Variety of Single/Multiple/Central Control
By using a Remote ON/OFF and Finish signal output functions, TNX timer is available in Sing/Multiple/
Central control that fits your Dust collector system.
1. General Timer Control
2. All you need to do is the connection of the main AC of two wires.
1. Each TNX Timer has 12 outputs. If you need 100 outputs, you use 9 sets of TNX Timers in one cycle sequence.
2. Only two wires can make them connection easily.
1. If you operate PLC of DCS controller, TNX Timer can be controlled by dry contact.
2. Communication contact : Dry contact
3. Finish contact : Dry contact
Specification | TNE Timer | ||||
| Pneumatic | ||||
| Solenoid encapsulated | ||||
| EP-ROM Digital | ||||
| Aluminum Die-Casting NEMA 4 | ||||
| 6p, 12p | ||||
| 0.001 ~ 0.999 sec | ||||
| 1 ~ 999 sec | ||||
| AC85 ~ 240V / 50 ~ 60Hz | ||||
| 2A | ||||
| 0.5 ~ 7.5 kg/㎠ | ||||
|
| ||||
| 1.25 pin & 1.25 4Y |
Output Signal
