• Working Width : 2400~4500mm 
• Needle Beam Stroke / Max stroke frequency -     30mm / 1000 s/min
• Needle per Liner meter : Lamella pitch / needles
                                              3mm / 7000 s/min
                                              3.5mm / 6000 s/min
 

▶ Machine Structure
 
• One needle beam is connected to one module box. According to the working width, more than two module boxes are connected to each other, and needle beams connected to these module boxes are operated up and down by one main motor. As each module box can be disassembled, it is easy to perform repair or maintenance when a problem is caused. 
• The bed plate is assembled with special steel blades spaced at regular lamella pitches(3mm, 3.5mm, 6mm and 7mm), instead of holes. When a blade is broken or damage, it is easy to replace it. 
• The machine is installed on the special vibroisolating rubber base to minimize the vibration of the machine. It is also easy to change the installation place of the machine. 

▶ Needle Board

• The needle board is made of special aluminum alloy steel and polyurethane, so that it is not deformed and its needle holes do not become loose after use for a long time. 

▶ Motors

• A variable AC-inverter (or DC motor) with 40HP based on working width of 2400mm, is used as main motor. It may vary depending on working width or work load. 
• A variable AC-inverter (or DC motor) with at least 1HP(0.75kw) is used as inlet and outlet motors.